The X9R Marauder is the largest and brightest torch Olight have ever produced and it is the most powerful torch that we have on the website. This powerhouse offers a mega jaw dropping 25000 lumens output on the highest level, before dropping down to 6400 lumens after 3 minutes to prevent the LEDs from overheating.
Six Cree XHP70.2 LEDs give the X9R the capability to produce 25000 lumens, but not without the help of the rechargeable lithium-ion battery pack that consists of eight high discharge 18650 cells. Powerful LEDs and a high discharge battery pack paired with the six individual orange peel reflectors that house the LEDs results in a beam with a central hotspot reaching an impressive 630 metre maximum range, accompanied by a large spill beam that provides massive flood lighting.
The battery pack is charge internally by inserting either the mains power adaptor or car charging adaptor into the charging port which is located on the neck of the torch next to the switch. If using the mains adaptor connect it to the wall plug adaptor and plug it into the mains, or alternatively plug the car charging adaptor into a car socket.
There are eight LEDs indicators either side of the power button. The eight on the right show the remaining battery power level while the torch is in use and they also light up while the torch is being charged. The top illuminated light will blink while charging, eventually turning solid blue at which point the light above will begin to blink, and this continues until all eight lights are solid blue when the torch is fully charged. A full charge takes approximately 4 hours via the mains and 7 hours via the car.
The eight blue LED indicators on the right display the current brightness level from 1-8. The little notches next to each LED have a number next to them to show the lumen output, but the numbers need to be x100 to show the true output. For example level 8 shows the number 250 next to it, but this needs to be x100 for the true output of 25000 lumens.
A single press of the side button turns the torch on/off and holding the button down while on will cycle through levels 1-8. The intelligent memory function will always remember the last output used for levels 1-4, and will remember levels 5-8 for 10 minutes after the light is turned off and after that time period is will revert to L4 as the memorised level.
Quickly double pressing the switch will enter L8 and holding the button down from off for 1 second will instantly access L1. Triple clicks of the button will activate the strobe mode and a single press will take you back to the normal modes.
As well as the active thermal management system that reduces the output when the temperature gets too hot, the X9R also features a nifty proximity sensor that will automatically reduce the output if the head of the torch becomes too close to an object when it is in the higher settings so that the heat expelled from the torch doesn't cause any damage.
A handy lockout feature prevents the torch from being accidentally activated when not in use. This is done by holding the switch down while the torch is off until it enters L1 and then turns off to signal that it has entered lockout mode. Press and hold for over 1 second to return to normal functionality.
A shoulder strap is included for easily carrying of the torch and is attached to the torch via the metal loop on the tail of the torch and a second metal loop that is tucked away on the head of the torch and needs to be pulled out in order to attached the strap. Also included is a rubber anti roll ring for the head of the torch that sits just above the pull out metal loop and prevents the torch from rolling on a flat surface.
The torch and accessories all come enclosed in a heavy duty hard shell case with large clips to secure the lid. The case also has the ability to alter the pressure inside as if the air pressure is altered due to altitude, on a plane for example, the case may not close or open. Therefore if the pressure needs to be altered, simply turn the counterbalance valve anti clockwise to balance the pressure.
L8: 25000 lumens; 3 minutes run-time, 6400 lumens; 1 hour, 40 minutes run-time*; 630 m beam range
L7: 12800 lumens; 10 minutes run-time, 6400 lumens; 1 hour, 30 minutes run-time**; 450 m beam range
L6: 6400 lumens; 2 hours run-time; 315 m beam range
L5: 3200 lumens; 4 hours run-time; 215 m beam range
L4: 1600 lumens; 8 hours run-time; 160 m beam range
L3: 800 lumens; 12 hours run-time; 115 m beam range
L2: 400 lumens; 18 hours run time; 85 m beam range
L1: 200 lumens; 27 hours run-time; 60 m beam range
Strobe: 12800 lumens; 13 Hz
Note: The above data is measured in lab conditions, therefore results may vary due to environmental and heat dissipation conditions.
*The overheat protection will decrease the output to 6400 lumens after 3 minutes to protect the LED.
**The overheat protection will decrease the output to 6400 lumens after 10 minutes to protect the LED.
Type: Search and rescue LED torch
Operating Modes: L1 / L2 / L3 / L4 / L5 / L6 / L7 / L8 / Strobe
Luminous Flux: Up to 25000 lumens
Lamp Type: 6 x Cree XHP70.2 LEDs
Reflector System: Orange peel textured reflector
Beam Range: Up to 630 m
Batteries Required: 6000 mAh Lithium-ion rechargeable battery pack
Run Time: See information above
Overall Length: 320 mm
Head Diameter: 100 mm
Body Diameter: 58 mm
Weight: 1855 grams (including battery)
Black Colour: Black with blue bezel and blue stainless steel ring around switch
Body Material: AL6061-T6 aluminium alloy unibody desgin
Body Finish: Type III hard anodised
Switch Type: Side mounted push button
Impact Resistance: 1 m
Environmental: Waterproof to IPX7 standard
Warranty: Torch: 10 years, Battery: 1 year
Regulatory Compliance: CE / RoHS
Packaging and Contents
Supplied in a hard carry case and contains:
Olight X9R Marauder torch x 1
6000 mAh lithium-ion battery pack x 1
DC16.8 V, 2 A mains adaptor x 1
UK mains 3 pin plug (to insert into the adaptor) x 1
DC 16.8 V, 1.5 A car charger x 1
Rubber anti roll ring x 1
Shoulder strap x 1
Manual x 1