The Xtar WP2H lithium-ion and LiFePO4 battery charger has two independent charging for 10440, 14500, 14650, 16340, 17670, 18350, 18500, 18650, 18700, 22650, 25500 and 26650 type batteries.
A choice of charging currents are available to suitable individual battery requirements, the modes are easily selected using the push button switch on the charging unit, just push the button to cycle through the modes until you arrive at the charging mode you wish to use.
This model also has the advantage of a USB port power output, so you can use the WP2H as a power bank, enabling you to charge phones, MP3 players, etc. The output provided is rated at 1000 mA and is powered by inserting a suitable battery or the Xtar battery carrier (see related products) into one charging bay of the WP2H.
The WP2H also has built-in short circuit and reverse polarity protection.
For charging 3.0 V, 3.2 V, 3.6 V, 3.7 V or 3.8 V nominal voltage lithium-ion or LiFePO4 batteries only.
Supplied with a UK mains adaptor and 12 volt car charger adaptor.
Note: Always use in accordance with the supplied instruction manual and read before first use, always remember to select the correct voltage for the battery you intend to charge.
Two independent charging bays
Real-time LED status indicators
Low heat design
Selection of charging currents (0.25 A, 0.5 A or 1 A)
Selection of charging voltages (3.2 V, 3.6 V or 3.8 V)
Three-phase charging method (TC, CC, CV)
0 V activation to repair over discharged batteries
Soft start function avoids damage from a large current surge
Low-voltage, over-current and over heat protection
Operation Temperature: Room temperature 0 to 40 ℃
Storage Temperature: 0 to 70 ℃
Input Voltage: 12 V dc 1000 mA
0.25 A CC: 250 mA ±30 mA
0.5 A CC: 500 mA ±50 mA
1.0 A CC: 1000 mA ±80 mA
TC for 0.25 A and 0.5 A Mode: ≦60 mA
TC for 1 A Mode: ≦100 mA
When voltage selector is set at 3.2 V the termination voltage is 3.6 V ±0.05 V
When voltage selector is set at 3.6 V the termination voltage is 4.2 V ±0.05 V
When voltage selector is set at 3.8 V the termination voltage is 4.35 V ±0.05 V
Dimensions: 118 mm (L) x 59 mm (W) x 30.5 mm (H)
Weight: 86 grams
USB Port Output Specifications
Operating temperature: 0 to 40 ℃
USB no-load voltage: 5.0 ±0.3 V
Maximum output current: 1000 mA
Battery output cut-off voltage: 3.0 ±0.2 V
Packaging and Contents
Supplied in retail packaging and includes:
Xtar WP2H dual bay charger x 1
UK mains adaptor x 1
12 V car adaptor x 1
1. Charge only rechargeable Lithium-ion or LiFePO4 batteries.
2. Charging any other types of batteries may cause them to leak rupture or explode.
3. Do not disassemble, modify the charger or attempt to use as a power source.
4. Always unplug the charger from outlet before attempting maintenance or cleaning.
5. This charger should only be used by persons with adequate training and knowledge