The Olight Seeker 3 is a high output rechargeable LED torch that is the successor to the Seeker 2 and is even more powerful with a lumen increase of 500 lumens, to now produce 3500 lumens output on the turbo setting. To prevent overheating the Seeker 3 will maintain the turbo brightness for 2 minutes, 30 seconds before dropping down to 1200 lumens to protect the LED.
Featuring four updated Osram high performance cool white LEDs, the Seeker 3 combines this with a TIR optic lens to provide a balanced beam profile with a central hotspot surrounded by spill light, offering a maximum range of 220 metres. The aluminium body of the torch features deeper bamboo style surface groves to provide an ergonomic and non slip grip.
The multi-function side-switch turns the torch on and off with each press and cycles through the brightness modes of low, mid and high when you hold down the button with the light on. For turbo access you double click the button and a triple click enters strobe. Moonlight mode can be accessed by holding the button down while the light is off.
When the light is turned on the battery level indicator built into the button will illuminate. A green light indicates above 60% power, an orange light indicates between 10%-60 % power, a red light indicates between 5%-10% powers and a red blinking light indicates less than 5% power and the torch should be charged. When turned on in moonlight the power indicator won't turn on unless the power is less than 10%.
The Seeker 3 features a lock-out function, so you don't have to worry about accidentally activating the light in your pocket or bag, and is activated by holding down the button for over 2 seconds while the light is turned off. A built in memory function automatically returns to your last brightness level from the off position (turbo will be memorised as high mode, the high mode will be memorised for 1 minute before reverting back to mid and the strobe cannot be memorised).
It is powered using the included Olight 21700 5000 mAh customised lithium-ion battery, which is recharged inside the torch using the included higher output MCC3 magnetic charging cable for faster charging times than it's predecessor. Simply connect the magnet to the base of the Seeker 3 and plug the USB-A end into a USB port or the mains using a USB adaptor. The indicator light on the magnet will go red while charging is in progress and turn green once charging is complete after approximately 4 hours, 30 minutes when using a 5V, 2A output.
Two timer settings are on the Seeker 3; long timer (9 minutes) and short timer (3 minutes). Double click and hold the side switch while the light is on to enter this setting. One blink indicates the 3 minutes mode, and two blinks indicates the 9 minutes mode.
Lock-out function to prevent accidental activation
Memory function remembers last mode used
Milled finger grooves for a comfortable feel in the hand
Battery status indicator built into the switch
3500 lumens; 2 minutes, 30 seconds run-time
1200 lumens; 1 hour, 27 minutes run-time
600 lumens; 37 minutes run-time
1200 lumens: 1 hour, 36 minutes run-time
600 lumens; 37 minutes run-time
300 lumens; 9 minutes run-time
Mid: 300 lumens; 9 hours run-time
Low: 50 lumens; 47 hours run-time
Moon: 5 lumens; 12 days run-time
The above data is measured indoors under 25°C in windless laboratory conditions. The data may vary due to environmental and heat dissipation conditions.
Please note: *The turbo & high settings will reduce in output to protect the LEDs from overheating, and will continue to decrease as the battery voltage decreases.
Type: Rechargeable hand LED torch
Operating Modes: Moonlight / Low / Mid / High / Turbo / Strobe
Luminous Flux: Up to 3500 lumens
Lamp Type: Osram cool white LED x 4
Reflector System: Smooth reflector
Beam Range: Up to 220 m
Batteries Required: customised 21700 5000 mAh lithium-ion rechargeable (included)
Overall Length: 128 mm
Head Diameter: 35 mm
Tail Diameter: 27.5 mm
Weight: 184 grams (including battery)
Body Colour: Black
Body Material: Constructed from aerospace grade aluminium alloy
Body Finish: Type III hard anodised
Switch Type: Single side push-button switch
Impact Resistance: 1.5 m
Environmental: Waterproof to IPX8 standard (2 m)
Warranty: 5 years (torch), 1 year (battery)
Regulatory Compliance: CE / RoHS
Packaging and Contents
Supplied in retail packaging and includes:
Olight Seeker 3 rechargeable LED torch x 1
Olight customised 21700 5000 mAh Li-ion battery x 1
MCC3 magnetic USB charging cable x 1
Lanyard x 1
Manual x 1