Olight M2R Pro Warrior Rechargeable LED Torch

The Olight M2R Pro Warrior is a new generation of rechargeable torch powered by a 21700 lithium-ion battery.

It is a dual switch tactical hand torch and is capable of 1800 lumens output on the highest turbo setting, before dropping down to 750 lumens after 4.5 minutes, and then after a further 2 hours 25 minutes the output will drop again to 250 lumens to prevent the LED from overheating.

The NW LED combined with a TIR reflector produces a big, defined wide hot spot with a uniform light for a good coverage of light and can reach up to a maximum of 300 metres beam range.

Tactical features have been improved on the M2R Pro, offering better grip because of the deeper kurling design, a more aggressive bezel with deeper crenellation, and an improved tail cap design that allows for easier operation while wearing gloves due to the raised button, but without compromising accidental activation thanks to the three raised struts that not only preventing it easily turning on but also allow for tail stand capability.

It is powered using the included Olight 21700 5000 mAh customised lithium-ion battery, which is recharged inside the torch using the included MCC3 magnetic charging cable. This new design charging cable charges the battery faster than the regular M2R, despite it being a larger capacity battery, all thanks to the 2 A output capability of the MMC3 cable.

Simply connect the magnet to the base of the M2R Pro and plug the USB end into a computer or the mains using a suitable USB adaptor (2 A recommended for fastest charging). The indicator light on the magnet will go red while charging is in progress and turn green once charging is complete after approximately 5 hours if the power supply is sufficient enough to support the 2 A output, otherwise the cable will output at a lower rate or 1 A or 1.5 A depending on the power supply.

Featuring six brightness levels and strobe, the torch is operated with the side switch and tactical tail switch. The torch can be turned on with a single press of the side switch and then hold the side switch to cycle through low, mid 2, mid 1 and high in turn and release at the desired output.

Moonlight mode can be accessed directly when the torch is off by pressing and holding down the switch. A quick double click gives instant access to the turbo mode, and another double click will exit turbo mode. Three quick presses will activate the strobe mode and a single press will exit. The memory function will remember the last mode used for moonlight, low, mid and high. A handy lockout function prevents the torch from being accidentally activated and is accessed by pressing and holding the side switch for 2 seconds.

The tactical tail switch is a quiet press button with minimal noise for tactical purposes and can be used in two modes; configuration 1 or configuration 2. The torch factory default setting is configuration 1 and to switch to configuration 2 you deep press the tail switch and while holding in down single press the side switch.

In configuration 1 the M2R Pro tail switch will provide momentary turbo illumination with a full press and hold or constant turbo with a quick full press and release, and momentary illumination of mid 2 with a half press and hold or with a quick half press will provide constant access to mid 2 output. In configuration 2 it will provide momentary turbo illumination with a half press and momentary strobe with a full press.

The detachable dual pocket clip can be attached to clothing easily from both sides while the durable lanyard provides security when you are carrying the torch in your hand. A sturdy holster is also included which is perfect for carrying the M2R Pro on your belt and it also features a flap with clip fastening to make sure your torch stays secure while you are on the move.

Operational Modes

Turbo*:
1800 lumens; 3 minutes run-time; 300 m beam range
750 lumens; 2 hours, 25 minutes run-time
250 lumens; 45 minutes run-time
High:
750 lumens; 2 hours, 40 minutes run-time; 185 m beam range
250 lumens; 40 minutes run-time
Mid 1:
250 lumens; 10 hoursrun-time; 110 m beam range
Mid 2:
60 lumens; 40 hours run-time; 55 m beam range
Low:
15 lumens; 130 hours run-time; 27 m beam range
Moonlight:
1 lumen; 50 days run-time

Please note: *The turbo setting will drop down twice as shown above to prevent the LED from overheating

Technical Details

Type: Professional hand-held LED torch
Operating Modes: Moonlight / Low / Mid 2 / Mid 1 / High / Turbo / Strobe
Luminous Flux: Up to 1800 lumens
Lamp Type: Neutral white LED
Lens: TIR lens
Beam Range: Up to 300 m
Batteries Required: 1 x customised 21700 Lithium-ion battery
Run Time: Up to 25 days at lowest setting
Overall Length: 136.5 mm
Head Diameter: 29.5 mm
Body Diameter: 26.2 mm
Weight: 179 grams (including battery)
Body Colour: Black
Body Material: Constructed from AL6061-T6 aluminium alloy
Body Finish: Type III hard-anodised
Switch Type: Side mounted and tail switch
Other Technology: Magnetic base
Impact Resistance: 1.5 m
Environmental: Waterproof to IPX8 Standard (2 m)
Warranty: 5 years (torch only)
Regulatory Compliance: CE / RoHS

Packaging and Contents

Supplied in retail packaging and contains:
Olight M2R Pro Warrior torch x 1
Olight customised 21700 5000 mAh Li-ion battery x 1
USB magnetic charging cable x 1
Stainless steel pocket clip x 1
Lanyard x 1
Holster x 1
Manual x 1

Be the first to Write a Review for this item!

Receive a great FREE GIFT from Torch Direct

To qualify simply spend over £75 with us, on any one order, minus any delivery fees.
You will then receive an Silverpoint Hunter XL120 LED Head Torch completely FREE!