Olight Freyr Multicolour Rechargeable LED Torch
Olight Freyr Multicolour Rechargeable LED TorchOlight Freyr Multicolour Rechargeable LED TorchOlight Freyr Multicolour Rechargeable LED Torch
Olight Freyr Multicolour Rechargeable LED TorchOlight Freyr Multicolour Rechargeable LED TorchOlight Freyr Multicolour Rechargeable LED Torch

Olight Freyr Multicolour Rechargeable LED Torch

Brand:  Olight
Product Code:  OL1060


20 in stock
max allowance of 20 characters

The Olight Freyr is a multicoloured torch offering white, red, green and blue outputs and is powered by a 21700 lithium-ion battery.

It is a dual switch tactical hand torch and is capable of 1750 lumens output on the highest turbo setting, before dropping down to 850 lumens after 2 minutes, and then after a further 2 hours 30 minutes the output will drop again to 300 lumens to prevent the LED from overheating.

The high performance cool white LED produces a uniform beam for a good coverage of light and can reach up to a maximum of 360 metres range. The RGB LEDs consist of a 635 nm red LED, a 515 nm green LED and a 470 nm blue LED and are useful for preserving night vision, inspection and signalling.

A silicone traffic wand is included to enhance the signalling functionality of the Freyr and once attached to the end provides a cone of light which can be used to direct traffic or as a marker etc.

Tactical features include a good grip because of the deep kurling design and a tail cap design that allows for easy operation while wearing gloves due to the raised button, but without compromising accidental activation thanks to the three raised struts that not only preventing it easily turning on but also allow for tail stand capability. There is also a proximity sensor under the front lens that will lower the output of the Freyr if it becomes close to an object in order to protect your eyesight and prevent overheating of the torch, please see the note below and the manual for further information.

It is powered using the included Olight 21700 5000 mAh customised lithium-ion battery, which is recharged inside the torch using the included MCC3 magnetic charging cable. Simply connect the magnet to the base of the Freyr and plug the USB end into a computer or the mains using a suitable USB adaptor (2 A recommended for fastest charging). The indicator light on the magnet will go red while charging is in progress and turn green once charging is complete after approximately 5 hours if the power supply is sufficient enough to support the 2 A output, otherwise the cable will output at a lower rate or 1 A or 1.5 A depending on the power supply.

Featuring three white brightness levels, RGB outputs and white strobe, the torch is operated with the side switch and tactical tail switch. The tactical tail switch is a quiet press button with minimal noise for tactical purposes and can only access the white outputs, while the side switch can primarily access the colour outputs and also the white outputs.

A single half press of the tail switch turns on white low, or a full press turns on high white and momentary operation is also possible in high and low by holding the button instead of releasing, with the light turning off once released. A single press of the side switch will turn on in the last used colour or moonlight, and once on hold down the button to cycle through red, green, blue and white moonlight outputs. Moonlight can also be directly accessed by holding the side switch for over 1 second from off. A quick double click of the side switch gives instant access to the high white mode, and another double click will cycle to low white mode. Three quick presses will activate the white strobe mode and a single press will exit.

The handy lockout function prevents the torch from being accidentally activated and is accessed by pressing and holding the side switch for 2 seconds. The moonlight mode will briefly flash and the light will be locked out, displaying only the red indicator if the button is pressed. To exit lockout press and hold the button down for over 1 second.

The detachable dual pocket clip can be attached to clothing easily from both sides while the durable holster provides security when you are carrying the torch in your bag or on a belt.

Please Note: The proximity sensor will not work if covered by dirt, water or scratches on the front lens. The sensing distance if between 3 cm to 50 cm depending of the reflectivity of the obstruction. The brightness will lower if an obstruction or bright light is in front of the sensor. The torch should only be used in moonlight or low when using the silicone traffic wand.

Operational Modes

1750 lumens; 2 minutes run-time; 360 m beam range
850 lumens; 2 hours, 30 minutes run-time
300 lumens; 28 minutes run-time
300 lumens; 9 hours, 30 minutes run-time; 150 m beam range
5 lumens; 15 days run-time; 19 m beam range
30 lumens; 20 hours run-time; 12 m beam range
60 lumens; 14 hours run-time; 19 m beam range
25 lumens; 12 hours run-time; 8 m beam range

Please note: *The turbo setting will drop down twice as shown above to prevent the LED from overheating

Technical Details

Type: Professional hand-held LED torch
Operating Modes: Moonlight / Low / High / Strobe / Red / Green / Blue
Luminous Flux: Up to 1750 lumens
Lamp Type: Cool white LED
Beam Range: Up to 360 m
Batteries Required: 1 x customised 21700 Lithium-ion battery
Overall Length: 136 mm
Head Diameter: 40.5 mm
Body Diameter: 25.6 mm
Weight: 202 grams (including battery)
Body Colour: Black
Body Material: Constructed from AL6061-T6 aluminium alloy
Body Finish: Type III hard-anodised
Switch Type: Side mounted and tail switch
Other Technology: Magnetic base
Impact Resistance: 1.5 m
Environmental: Waterproof to IPX8 Standard (2 m)
Warranty: 5 years (torch only)
Regulatory Compliance: CE / RoHS

Packaging and Contents

Supplied in retail packaging and contains:
Olight Freyr LED torch x 1
Olight customised 21700 5000 mAh Li-ion battery x 1
USB MCC3 magnetic charging cable x 1
Stainless steel pocket clip x 1
Silicone traffic wand x 1
Holster x 1
Manual x 1

Olight Customised 21700 5000 mAh 3.6 V Lithium-ion Battery

Olight Customised 21700 5000 mAh 3.6 V Lithium-ion Battery

This Olight customised battery is compatible with the Olight Freyr, Seeker 2, Seeker 2 Pro, Warrior X Pro, Warrior X Turbo & M2R Pro Warrior only.

Out of Stock

Due to shipping regulations this battery can only be shipped to the Mainland UK, unless it is sent with a compatible torch or battery charger.

[More details]

Olight E-WM25 Weapon Mount

Olight E-WM25 Weapon Mount

Fits Olight models Warrior X, M2R, M2T, M20SX, M3X-UT, R20 and M23 or torches with a body diameter of 24.4 to 27.4 mm

11 in stock

The Olight E-WM25 is a light weight weapon mount built with high-strength engineering plastics and aluminum alloy and is designed to attach to a firearm with a MIL-STD-1913 (Picatinny) rail without getting in the way of your grip or sights.

[More details]
£10.95Add to Basket

Compact USB Charger (2100 mA Output)

Compact USB Charger (2100 mA Output)

15 in stock

This compact USB charger has a power output of 2100 mA, making it ideal for charging many devices that charge via a USB port.

[More details]
£5.95Add to Basket

Olight Omino Magnetic 4 Port Charging Dock

Olight Omino Magnetic 4 Port Charging Dock

Compatible with Olight torches that can charge via MCC1A & MCC3 magnetic cables.

10 in stock

The Olight Omino magnetic charging base has four charging ports and is designed to charge a a wide range of Olight torches that are compatible with the newer MCC1 and MCC3 charging cables.

[More details]
£45.95Add to Basket

Olight MCC3 USB Magnetic Charging Cable

Olight MCC3 USB Magnetic Charging Cable

Compatible with Olight S1R, S1R II, S2R, S2R II, S10R III, S30R III, H2R, M2R, M2R Pro, Seeker 2, Seeker 2 Pro, PL-PRO Valkyrie, Warrior X, Warrior X Pro, Warrior X Turbo and Baton Pro

8 in stock

The Olight USB MCC3 serves as a spare or replacement charging cable for the Olight S1R, S1R II, S2R, S2R II, S10R III, S30R III, H2R, M2R, M2R Pro, Seeker 2, Seeker 2 Pro, PL-PRO Valkyrie, Warrior X, Warrior X Pro, Warrior X Turbo and Baton Pro.

[More details]
£14.95Add to Basket

Be the first to Write a Review for this item!

Receive a great FREE GIFT from Torch Direct

To qualify simply spend over £50 with us, on any one order, minus any delivery fees.
You will then receive a Mercury FL05C 5 W Cree LED Torch completely FREE!

Free gift offer from Torch Direct Ltd

Make it personal with our laser engraving service!

We charge £3.95 per engraving and all you have to do to obtain this service is complete the text form above with the text that you wish to be laser engraved. The text box is located just above the add to basket button, do this before adding your chosen product to your shopping basket.

You can chose to engrave a name, slogan or any text you want.

We are able to reproduce lowercase, uppercase, numbers and punctuation marks, and you may use a maximum of 20 characters per item. Please take great care when typing your chosen text as our system will capture, process, and replicate exactly what has been typed by you. Mistakes cannot be corrected after the engraving has been completed and refunds or exchanges will not be offered.

How do we engrave your product?

We use a top quality fibre laser engraving machine, which provides an accurate beam of laser light to mark your product perfectly and permanently.

Which typeface do we use for engraving and what size is it?

We use a typeface called 'Arial' for all our engraving as we find it gives the best results overall. Depending on which product is being engraved, our machine operators will adjust the text size to fit any available space.

Some samples from our engraving gallery (click to zoom)

If you would like to see more examples then please visit our Engraving Service page.