The TK26R is tactical rechargeable torch designed with Law enforcement and Military in mind due to the tri colour outputs of white, red and green, but it is also great for anyone else who has a need for multiple coloured outputs.
Featuring a Luminus SST40 cool white LED and a smooth reflecor the TK26R has a maximum output of 1500 lumens with a 350 m beam range, while the two Cree XP-E2 LEDs provide a red output of 150 lumens and a green output of 200 lumens.
There are two tail buttons that and a side button that control the outputs. The torch is turned on and off with the circular tactical tail button and also provides momentary illumination with a half press and will go off when released. Once turned on the second functional tail switch cycles through low, mid, high and turbo with each press or accesses strobe when held down for 0.8 seconds. The last used white brightness setting, except strobe, will be remembered the next time the torch is turned on.
The red and green lights are controlled with the side button and once the torch is turned on in white with the tail switch, you then press the side button once to access the red output and each press will then cycle between green and red outputs, which is useful for traffic or railway signalling.
Included is a Fenix 18650 3500 mAh lithium-ion battery, which is charged inside the TK26R via the USB Type C port on the neck of the torch. Simply remove the dust cover from the charging port and insert the included cable, and then connect the standard USB end to a USB power source such as a computer or mains USB adaptor.
The LED indicator on the side switch will turn red while charging is in progress and will go green once charging is complete after approximately 3 hours for a full charge. Ensure the dust cover is placed back over the charging port after charging to maintain the dust ingress protection rating.
The battery level indicator built into the switch will light up for 3 seconds when the torch is first turned on, with either a green, green flashing, red or red flashing light to show the battery power remaining and notify you when the battery needs charging.
There is also a built-in overheat protection that will automatically lower the brightness if the torch reaches 65°C or over in the higher settings, in order to protect the LED. There is also a low voltage warning function that will decrease the output when the voltage becomes low, and once low mode is reached the indicator will flash red to remind you to charge the battery.
The TK26R can be weapon mounted using the Fenix ALG-01/ALG-00, or it an be bike mounted with the ALB-10 quick release bike mount, which can all be purchased separately.
White, red and green outputs available
Faster charging with USB Type C
Side switch for red/green selection
Functional tail switch for white output selection
Overheat protection to protect the LED and inner components
Anti-roll and anti-slip body design
Low voltage warning function
Memory circuit remembers last white brightness setting
Digitally regulated output to maintain stable output
Reverse polarity protection, protects from improper battery installation
Using 1 x Fenix ARB-L18 3500 mAh lithium-ion battery:
Turbo: 1500 lumens; 1 hour, 25 minutes run-time*; 350 metres beam range
High: 350 lumens; 4 hours, 40 minutes run-time; 170 m beam range
Mid: 150 lumens; 10 hours, 50 minutes run-time; 110 metres beam range
Low: 10 lumens; 100 hours run-time; 30 metres beam range
Strobe: 1500 lumens
Red: 150 lumens; 4 hours, 20 minutes run-time; 30 m beam range
Green: 200 lumens; 5 hours, 10 minutes run-time; 40 m beam range
Note: *The turbo output is measured at total run-time, including output at reduced levels due to temperature or the built-in protection mechanism.
Type: Tri colour tactical hand held LED torch
Operating Modes: Turbo / High / Mid / Low / Strobe / Red / Green
Luminous Flux: Up to 1500 lumens
Lamp Type: Luminus SST40 cool white LED x1 / Cree XP-E2 LED x 2
Beam Range: Up to 350 m
Batteries Required: 2 x CR123A lithium metal or 1 x 18650 lithium-ion
Charging Time: Approximately 3 hours (based on the included battery)
Overall Length: 150 mm
Head Diameter: 40 mm
Barrel Diameter: 25.4 mm
Weight: 157 grams (excluding batteries)
Body Colour: Black
Body Material: Durable A6061-T6 aluminium
Body Finish: Premium type III hard-anodised anti-abrasive finish
Lens Type: Toughened ultra clear glass with anti-reflective coating
Switch Type: Dual tail cap switch and side switch
Impact Resistance: 1 m
Environmental: Waterproof and dust resistant to IP68 standard (2 m)
Warranty: 5 years (torch), 1 year (battery)
Regulatory Compliance: CE / RoHS
Packaging and Contents
Supplied in retail packaging and includes:
Fenix 18650 3500 mAh lithium-ion battery x 1
Fenix TK26R LED torch x 1
Lanyard x 1
Holster x 1
Spare O-ring x 1
Type C USB charging cable x 1
Manual x 1