The Fenix TK11 TAC is specifically designed for Military and Law Enforcement professionals and features an all metal tactical tail switch that has a rotary collar to easily change between tactical, duty and lockout modes.
Utilising a Luminus SST40 LED it offers a maximum output of 1600 lumens on high and throws the beam up to 335 metres, providing an excellent combination of output and distance.
The newly developed Advanced Pulse Frequency signal transmission technology uses a digital switch signal instead of the usual current signal to greatly increase reliability. Combined with patented mechanical switches this allows Fenix to create a smaller, more efficient light that is much less prone to switching interference than similar magnetic tail cap systems.
Two battery options are available for use with the TK11 TAC. You can either use a Fenix 18650 rechargeable lithium-ion battery (not included) or alternatively you can use two CR123A non-rechargeable lithium metal batteries (not included).
Two user modes are available, with different outputs for each mode. In tactical mode the user will have access to high and strobe only, and in duty mode all outputs of low, mid, high and strobe are accessible. The rotary collar below the tail switch allows the user to select the mode by turning it clockwise for tactical mode or anticlockwise for duty mode.
When tactical mode is selected half press the button for momentary high access or fully press the button for constant high access. In duty mode half press for momentary operation, or continually half press to cycle through low, mid, high. Fully press in the switch to constantly turn the torch on at the desired output and full press to turn the light off. Once on, the modes can also be cycled through with half presses.
Strobe can be accessed from either tactical or duty by fully pressing and holding the button for 0.8 seconds. To exit strobe either half press to return to the previous brightness or fully press the button to turn the torch off.
If left in the centre position the torch will be in lockout mode and the button will not work. The torch can be put into the locked position while the torch is turned on to lock in that output to ensure the light stays on and the tail switch cannot be accidentally pressed and change mode, or alternatively with the light off the torch will be locked in the off position to prevent accidental activation when not in use.
Intelligent overheat protection will lower the output of the torch if the temperature reaches 60°C in order to cool the torch and prevent damage from overheating. Once the torch has cooled the high mode can be selected again. If the battery voltage drops below the preset level the torch is programmed to downshift to a lower brightness level until low output is reached, at which point the light will flash 3 times every 5 minutes to remind you to recharge or replace your battery.
The pocket clip allows easy attachment to a pocket, clothing or backpack and the included holster and lanyard make carrying it easy.
Tactical tail switch and rotary mode selection collar
Tactical and duty modes for flexible use
Low voltage warning function
Lockout mode to prevent accidental activation
Reverse polarity protection
Over heat protection
Low: 50 lumens; 47 hours, 30 minutes run-time; 60 m beam range
Mid: 500 lumens; 4 hours, 30 minutes run-time; 195 m beam range
High: 1600 lumens; 2 hours run-time; 335 m beam range*
Strobe: 1600 lumens
Note: *The turbo output is measured at total run-time, including output at reduced levels due to temperature or the built-in protection mechanism.
Tested in laboratory conditions to ANSI/PLATO FL1 standard using 1 x Fenix ARB-L18-3500 18650 lithium-ion rechargeable battery under the temperature of 21±3°C and humidity of 50% - 80%. Results may vary between torch, battery and environments.
Important Battery and Battery Charger Information
Primary Cells - Please note that CR123A lithium metal primary battery cells are not rechargeable.
Rechargeable Cells - If you are intending to use lithium-ion rechargeable batteries then you will also need to purchase a suitable battery charger if you do not already have one.
Please click on the Accessories tab above to view compatible batteries and battery chargers.
Type: Hand held rechargeable LED torch
Operating Modes: Low / Mid / High / Turbo / Strobe
Luminous Flux: Up to 1600 lumens
Lamp Type: Luminus SST40 LED
Beam Range: Up to 335 m
Batteries Required: 1 x Fenix 18650 L18 series lithium-ion rechargeable or 2 x CR123A lithium metal (not included)
Overall Length: 140 mm
Head Diameter: 34 mm
Body Diameter: 23.5 mm
Weight: 114 grams (excluding battery)
Body Colour: Black
Body Material: A6061-T6 aluminium
Body Finish: Premium type III hard anodised anti-abrasive finish
Window Type: Toughened ultra-clear glass lens with anti-reflective coating
Reflector: Smooth for excellent beam throw
Switch Type: Tactical tail switch and rotary mode switch
Impact Resistance: 1 m
Environmental: Waterproof and dust resistant to IP68 Standard (2 m)
Warranty: 5 years
Regulatory Compliance: CE / RoHS
Packaging and Contents
Supplied in retail packaging and includes:
Fenix TK11 TAC LED torch x 1
Holster x 1
Spare O-ring x 1
Manual x 1