Small but mighty, the updated Fenix LD02 V2.0 now offers dual outputs with a neutral white light and a Ultraviolet LED.
The UV light is 200 mW with a wavelength of 365 nm and is great for a wide range of uses including bank note, document and ID inspection, Smart Water and SelectaDNA.
The neutral white Cree XQ-E HI LED has a high colour rendering index (CRI ≥ 90) and provides an output of 70 lumens. The high CRI means the beam resembles that of morning sunlight, making colours appear more clearly to the human eye and also reducing eye strain, which makes the mid mode perfect for night reading.
The stainless steel tail switch turns the torch on and off with a full click of the button and once turned on, half presses cycle through low, mid, high and UV. The LD02 V2.0 is powered by a single AAA alkaline (included) or NiMH battery.
The last used brighness level will be remembered next time the torch is turned on, so you can leave it in your preferred output for your convenience.
Note: As this is a high output device, power will automatically reduce from 70 lumens to 50 lumens output after 1 minute, 30 seconds of constant operation to protect the LED from overheating. Once the temperature has cooled the high output can be re-selected.
Our UV products are at the safest end of the UV spectrum (UVA wavelength) however they should only be used by adults and responsible persons. Avoid skin exposure or eye contact. For more UV information please follow this link: https://en.wikipedia.org/wiki/Ultraviolet
Dual white and UV outputs
Uses one AAA battery (alkaline or NiMH)
Digitally regulated circuit maintains constant brightness
Easy, single hand operation
Reverse polarity protection
Lightweight, compact design
Built-in pocket clip
Using 1 x AAA alkaline battery:
Low: 1 lumen; 75 hours run-time; 6 m beam range
Mid: 25 lumen; 2 hours, 40 minutes run-time; 27 m beam range
High: 70 Lumen; 40 minutes run-time; 48 m beam range*
UV Light: 200 mW; 4 hours run-time
Using 1 x AAA NiMH battery:
Low: 1 lumen; 45 hours run-time; 6 m beam range
Mid: 25 lumen; 2 hours, 55 minutes run-time; 27 m beam range
High: 70 Lumen; 45 minutes run-time; 48 m beam range*
UV Light: 200 mW; 3 hours run-time
Note: *Accumulated run-time due to the automatic downshift overheat protection
Tested to ANSI/NEMA FL1 standard.
Important Battery and Battery Charger Information
Primary Cells - Please note that AAA alkaline primary battery cells are not rechargeable.
Rechargeable Cells - If you are intending to use NiMH rechargeable batteries then you will also need to purchase a suitable battery charger if you do not already have one.
Please click on the Product Accessories tab above to view compatible batteries and battery chargers.
Type: Mini LED pocket torch
Operating Modes: Low / Mid / High / UV
Luminous Flux: Up to 70 lumens
Lamp Type: CREE XQ-E HI LED
Beam Range: Up to 48 m
Batteries Required: 1 x AAA alkaline (included) or 1 x AAA NiMH (not included)
Run Time: Up To 75 hours (on low mode)
Overall Length: 92 mm
Body Diameter: 13.5 mm
Weight: 24 grams (excluding battery)
Body Colour: Black and silver
Body Material: Made from oxidation resistant aluminium and stainless steel
Body Finish: Premium Type III hard-anodised anti-abrasive finish
Switch Type: End cap push button
Impact Resistance: 1 m
Environmental: Waterproof to IP68 standard (2 m)
Warranty: 5 years free repair, limited lifetime
Regulatory Compliance: CE / RoHS
Packaging and Contents
Supplied in retail packaging and includes:
Fenix LD02 V2.0 LED torch x 1
Spare O-ring x 1
AAA alkaline battery x 1
Manual x 1