Fenix E16 EDC LED Torch
Fenix E16 EDC LED TorchFenix E16 EDC LED TorchFenix E16 EDC LED Torch
Fenix E16 EDC LED TorchFenix E16 EDC LED TorchFenix E16 EDC LED Torch

Fenix E16 EDC LED Torch

  (1 Review)
Availability:  2 in stock
Brand:  Fenix
Product Code:  E16-EDC
 
maximum allowance of 10 characters
£39.95

The Fenix E16 is a compact EDC torch that is capable of 700 lumens maximum output from the Cree XP-L HI neutral white LED.

It is powered by either one CR123A lithium metal non-rechargeable battery or one high discharge current 16340 lithium-ion rechargeable battery of at least 2.5 A, such as the Fenix ARB-L16-700UP high discharge lithium-ion battery, offering different outputs depending on which battery is used. The higher maximum 700 lumen output with the HD 16340 lithium-ion battery and a lower 300 lumen maximum output with the CR123A lithium metal battery. The run-times and beam ranges also vary depending upon the battery type being used.

The push button switch sits on top of the torch and activates the white light by holding it for 0.5 seconds and then each press cycles through the modes of low, mid, high and turbo. Hold the button down for 0.5 seconds to turn the light off, or continue to hold the button for 1.2 seconds to access the strobe function and single press to revert back to the general outputs. The intelligent memory circuit remembers the last white brightness setting used.

The low battery voltage warning function is programmed to downshift to a lower brightness level when the voltage drops below the preset level. Once it reaches low output the light blinks three times every 5 minutes to remind you to charge your 16340 battery (this function does not work with a CR123A battery).

Two ways of locking out the torch to prevent accidental activation are possible. The first is the electronic lockout where you press the button twice within 0.5 seconds and the second is the physical lockout where the pocket clip is rotated so that it covers the button to stop it being able to be presses.

Because the torch will accumulate a lot of heat at turbo level when used for extended periods, the E16 will automatically step down by a few lumens to prevent high surface temperature and damage to the LED. Once the temperature has reduced the turbo output can then be re-selected.

Please Note: If you using a 16340 lithium-ion battery it must have a high discharge current of at least 2.5 A, as a standard 16340 battery can not provide enough power for the E16 to function properly at the high output levels.

Product Features

Stainless steel side switch for easy control
Low-voltage warning function to remind you to charge the battery
Digitally regulated output maintains constant brightness
Over-heat protection to avoid high-temperature of the surface
Reverse polarity protection protects from improper battery installation

Operational Modes

Using one 16340 high discharge  lithium-ion battery:
Low: 3 lumens; 70 hours run-time; 13 m beam range
Mid: 30 lumens; 11 hours, 55 minutes run-time; 31 m beam range
High: 150 lumens; 2 hours run-time; 66 m beam range
Turbo: 700 lumens; 1 hour, 5 minutes run-time; 142 m beam range*
Strobe: 700 lumens

Using one CR123A lithium metal battery:
Low: 3 lumens; 110 hours run-time; 13 m beam range
Mid: 30 lumens; 25 hours run-time; 31 m beam range
High: 150 lumens; 2 hours, 50 minutes run-time; 66 m beam range
Turbo: 300 lumens; 1 hour, 55 minutes run-time; 93 m beam range*
Strobe: 700 lumens

The above parameters are approximate and may vary between torch, battery and environment.

Please Note: *The run-time is the cumulative run-time with the low-voltage active.


Technical Details

Type: Rechargeable LED torch
Operating Modes: Low / Mid / High / Turbo / Strobe
Luminous Flux: Up to 700 lumens
Lamp Type: 1 x Cree XP-L HI white LED
Beam Range: Up to 142 m
Batteries Required: 1 x high discharge 16340 lithium-ion or 1 x CR123A (battery not included)
Run Time: Up to 110 hours (low setting)
Overall Length: 51 mm
Head Diameter: 21.1 mm
Body Diameter: 19.8 mm
Weight: 22 grams (excluding battery)
Body Colour: Black with copper colour detail
Body Material: Durable high strength and oxidation resistant aluminium
Body Finish: Type III hard anodised anti abrasive finish
Switch Type: Side push button
Impact Resistance: 1 m
Environmental: Waterproof to IP68 standard (2 m)
Warranty: 5 years
Regulatory Compliance: CE / RoHS


Packaging and Contents

Supplied in retail packaging and includes:
Fenix E16 LED torch x 1
Pocket clip x 1
Lanyard x 1
Spare O-ring x 1
Key ring x 1
Manual x 1

Fenix 16340 USB Rechargeable High Discharge 700 mAh Li-ion Protected Battery

Fenix 16340 USB Rechargeable High Discharge 700 mAh Li-ion Protected Battery

Can be charged via the built-in Micro USB port or in a Fenix battery charger
Equivalent to RCR123A / ICR123 / LIR123A

Availability:  9 in stock

The Fenix ARB-L16-700UP is a premium quality high capacity 16340, 700 mAh lithium-ion battery specifically designed for high intensity torch use, but unlike the standard ARB-L16-700U USB battery, this version has a high continuous discharge current of 2.5 A.

[More details]
£9.95Add to Basket

Xtar ANT MC1 Plus Single Bay Lithium-ion Battery Charger

Xtar ANT MC1 Plus Single Bay Lithium-ion Battery Charger

Charges Li-ion/IMR/INR/ICR batteries

Availability:  10+ in stock

The Xtar ANT MC1 Plus is a lithium-ion battery charger with a single charging bay that has a charging current of either 0.5 A or 1 A. A small display screen will light up and show the charging current and the charging progress of the battery. The charger will automatically stop charging when the battery is full.

[More details]
£4.95RRP: £8.95Add to Basket

Storacell CR123A or RCR123 8 Cell Battery Holder

Storacell CR123A or RCR123 8 Cell Battery Holder

Availability:  10+ in stock

Organise and store your CR123A or RCR123 batteries in this Storacell hard plastic caddy. These holders were originally designed for pilots, but they are also great for camping, boating, travel or at home.

[More details]
£5.95Add to Basket

Storacell Slimline CR123A or RCR123 4 Cell Battery Holder

Storacell Slimline CR123A or RCR123 4 Cell Battery Holder

Availability:  7 in stock

Organise and store your CR123A or RCR123 batteries in this Storacell hard plastic caddy. These holders were originally designed for pilots, but they are also great for camping, boating, travel or at home.

[More details]
£5.25Add to Basket

(1 Review):  

Rating:  
Great EDC
Monday, 26 November 2018  | 

Great little EDC that's so small and pocketable.
700 Lumens output is amazing but its short lived as the torch gets very hot and turns down the wick to protect itself (if you can hold it long enough!). Hence turbo can only be used for short bursts if the battery has enough charge.

Think of it as a 150 lumen torch that is capable of short 700 lumen bursts.
I haven't tried it with a non-rechargable battery and the 300 lumen output.

3 lumen mode is a great as a reading light.

My only niggle is the clip. Its very stiff and when securing on something like a thick belt the clip moves around on the torch body and has started to scratch the anodising. So I'm unclear how this will stand the test

Great item but if you want 700 lumens for long periods look for something bigger that can handle the power dissipation.

Receive a great FREE GIFT from Torch Direct

To qualify simply spend over £50 with us, on any one order, minus any delivery fees.
You will then receive an Xtar LED Key Ring Torch completely FREE!

Free gift offer from Torch Direct Ltd

Make it personal with our laser engraving service!

We charge £2.95 per engraving and all you have to do to obtain this service is complete the text form above with the text that you wish to be laser engraved. The text box is located just above the add to basket button, do this before adding your chosen product to your shopping basket.

You can chose to engrave a name, slogan or any text you want.

We are able to reproduce lowercase, uppercase, numbers and punctuation marks, and you may use a maximum of 20 characters per item. Please take great care when typing your chosen text as our system will capture, process, and replicate exactly what has been typed by you. Mistakes cannot be corrected after the engraving has been completed and refunds or exchanges will not be offered.

How do we engrave your product?

We use a top quality fibre laser engraving machine, which provides an accurate beam of laser light to mark your product perfectly and permanently.

Which typeface do we use for engraving and what size is it?

We use a typeface called 'Arial' for all our engraving as we find it gives the best results overall. Depending on which product is being engraved, our machine operators will adjust the text size to fit any available space.

Some samples from our engraving gallery (click to zoom)

If you would like to see more examples then please visit our Engraving Service page.

Customers Who Bought This Item Also Bought
Fenix 16340 USB Rechargeable High Discharge 700 mAh Li-ion Protected Battery

Fenix 16340 USB Rechargeable High Discharge 700 mAh Li-ion Protected Battery

Can be charged via the built-in Micro USB port or in a Fenix battery charger
Equivalent to RCR123A / ICR123 / LIR123A

Availability:  9 in stock

The Fenix ARB-L16-700UP is a premium quality high capacity 16340, 700 mAh lithium-ion battery specifically designed for high intensity torch use, but unlike the standard ARB-L16-700U USB battery, this version has a high continuous discharge current of 2.5 A.

[More details]
£9.95Add to Basket

Silverpoint Hunter XL120 LED Head Torch

Silverpoint Hunter XL120 LED Head Torch

120 Lumens Output

Availability:  10+ in stock

The Silverpoint Hunter XL120 provides a maximum output of 120 lumens white light from the central 3 watt LED and is available in a choice of blue or red body colour. The main LED offers high, low and flashing outputs while two side 5 mm LEDs provide a constant on and flashing outputs.

[More details]
£11.95Add to Basket

Xtar LED Key Ring Torch

Xtar LED Key Ring Torch

Availability:  10+ in stock

These key ring torches are fantastic, once you add one to your key ring, you will wonder how you ever lived without it. The casing is made of a tough polycarbonate, which can withstand a lot of day to day punishment.

[More details]
£1.95Add to Basket

Fenix ARE-X2 Dual Bay Lithium-ion/NiMH Battery Charger

Fenix ARE-X2 Dual Bay Lithium-ion/NiMH Battery Charger

This model also features a USB port output, enabling you to charge phones, etc.

Availability:  10+ in stock

The Fenix ARE-X2 is a dual bay battery charger capable of charging lithium-ion, NiMH and NiCd type batteries. Compatible with the following batteries: Lithium-ion: 26650, 18650, 16340/RCR123A, 14500 and 10440. NiMH/NiCd: AA, AAA

[More details]
£19.95Add to Basket

USB Type A Plug to Micro USB 5 Pin Cable

USB Type A Plug to Micro USB 5 Pin Cable

Availability:  10+ in stock

This is a cable which has a USB cable with type A plug at one end and a micro type B five pin plug at the other end, the cable is 1.5 metres in length. Ideal for charging any devices that have a Micro USB port, such as a smart phone, tablet or many of our LED torches.

[More details]
£1.75RRP: £1.95Add to Basket

Compact USB Charger (2100 mA Output)

Compact USB Charger (2100 mA Output)

Availability:  2 in stock

This compact USB charger has a power output of 2100 mA, making it ideal for charging many devices that charge via a USB port.

[More details]
£5.95Add to Basket

Fenix ARE-X1 Single Bay Lithium-ion Battery Charger

Fenix ARE-X1 Single Bay Lithium-ion Battery Charger

Features Power Bank Function

Availability:  9 in stock

The Fenix ARE-X1 is a lithium-ion battery charger with a single charging bay. It is suitable for charging one 18650 or one 26650 lithium-ion battery and is supplied with a USB charging cable.

[More details]
£11.95Add to Basket

Fenix HL/HM Series Head Torch Storage Case

Fenix HL/HM Series Head Torch Storage Case

Designed for the Fenix HL10, HL12R, HL15, HL16, HL18R, HL23, HL26R, HL30, HL23R, HL35, HL40R, HL50, HL55, HL60R and HM50R Head Torches

Availability:  6 in stock

This Fenix head torch storage case is designed for the HL/HM series of head torches and fits the Fenix HL10, HL12R, HL15, HL16, HL18R, HL23, HL26R, HL30, HL23R, HL35, HL40R, HL50, HL55, HL60R and HM50R.

[More details]
£6.95Add to Basket