The Fenix E03R is Fenix's first rechargeable key ring torch, and it doesn't disappoint, offering 260 lumens white light from a compact, lightweight and sleek design. It also features a red light setting which is useful for low level lighting and preserving night vision.
Weighing only 22 grams and smaller than a car key, the E03R can easily be suspended from the included key ring on car keys, a key chain or with the built in loop on back or the light you could thread through a wrist or neck lanyard for carrying.
It is powered by a built-in lithium polymer rechargeable battery which is recharged via the USB Type-C charging port located on the side of the torch. Lift the dust cover and plug in the included USB Type-C cable at one end and plug the other end into a standard USB-A port or a compatible USB adaptor. The charging indicator light on the switch will go red while charging is in progress and turn green once charging is complete after approximately 1 hour, 20 minutes.
The side switch activates the white light by holding it for 0.5 seconds and then each press cycles through the modes of eco, low, mid, high. The red light is accessed by holding down the button for 1.2 seconds and each press with cycle between the constant red and red flash. Hold the switch for 0.5 seconds to turn the light off.
To prevent accidental activation the E03R has a slightly recessed switch to minimise it being pressed and the torch also features an electronic lockout function. The electronic lockout is accessed by two quick presses of the button while the light is off and the torch will blink twice to indicate it has entered lock-out mode.
A built-in battery level indicator displays the battery status for 3 seconds when the button is single pressed with the light off. It will show either a solid green, green flashing, solid red or red flashing light. There is also a low battery voltage warning function is programmed to downshift to a lower brightness level when the voltage drops below the preset level. Once it reaches eco output it will blink red to remind you to charge the battery.
Intelligent overheat protection will automatically downshift the brightness output when the torch is used for extended periods in the high setting in order to lower the temperature. The high brightness setting can be reset if required.
Lock-out function & battery level indicator
Low-voltage warning function to remind you to recharge the battery
White and red light outputs
Over-heat protection to avoid high-temperature of the surface
Eco: 5 lumens; 18 hours run-time; 7 m beam range
Low: 30 lumens; 3 hours run-time; 16 m beam range
Mid: 80 lumens; 1 hour, 15 minutes run-time; 25 m beam range
High: 260 lumens; 45 minutes run-time; 42 m beam range*
Red: 4 lumens; 4 hours, 30 minutes run-time; 10 m beam range
Red Flash: 4 lumens
Note: *The high output is measured in total run-time including any reduced output due to the temperature protection mechanism in the design.
Lab tested to ANSI / PLATO FL 1 standard using the built-in 200 mAh lithium polymer rechargeable battery. Real use conditions may be different and therefore results may vary.
Type: EDC torch
Operating Modes: Eco / Low / Mid / High / Red / Red Flash
Luminous Flux: Up to 260 lumens
Lamp Type: MATCH CA18 white light LED / Everlight 2835 red light LED
Beam Range: Up to 42 m
Batteries Required: Built-in 200 mAh lithium polymer battery
Overall Length: 47 mm
Diameter: 24 x 12 mm
Weight: 22 grams
Body Colour: Dark grey
Body Material: All metal CNC machined body
Body Finish: Type III hard anodised anti abrasive finish
Switch Type: Side mounted switch
Impact Resistance: 1 m
Environmental: Dust proof and water resistant to IP66 standard
Warranty: 2 years
Regulatory Compliance: CE / RoHS
Packaging and Contents
Supplied in retail packaging and includes:
Fenix E03R LED torch x 1
USB-A to USB-C charging cable x 1
Split ring key ring attachment x 1
Manual x 1